Filters: partyWithName: Natural Hazards (X) > partyWithName: Pacific Coastal and Marine Science Center (X)
Folders: ROOT > ScienceBase Catalog ( Show direct descendants )
748 results (56ms)
LocationFilters
Date Range
Extensions Types
Contacts
Categories Tag Types Tag Schemes |
Time series data of water surface elevation and wave height were acquired at ten locations for 517 days (in three separate deployments) off the north coast of Roi-Namur Island, Kwajalein Atoll, Marshall Islands, in support of a study on the coastal circulation patterns and the transformation of surface waves over the coral reefs. The relative placement of sensors on the reefs were as follows: ROI13W1 and ROI13E1 – fore reef ROI13W2 and ROI13E2 – outer reef flat ROI13W1 and ROI13E1 – middle reef flat ROI13W1 and ROI13E1 – inner reef flat
This dataset includes swell-filtered, high-resolution seismic-reflection data jointly collected by the U.S. Geological Survey (USGS) and Oregon State University in 2010, between Shelter Cove and Fort Bragg in northern California.
An unmanned aerial system (UAS) was used to acquire high-resolution imagery of the intertidal zone at West Whidbey Island, Washington on June 4, 2019. This imagery was processed using structure-from-motion (SfM) photogrammetric techniques to derive a high-resolution digital surface model (DSM), orthomosaic imagery, and topographic point clouds. In order to maximize the extent of the subaerially exposed area, the survey was timed to coincide with a spring low tide occurring at approximately 18:02 Universal Coordinated Time (UTC) (11:02 Pacific Daylight Time (PDT)), with a predicted water level of -0.74 meters below mean lower-low water (MLLW) at the Sunset Beach NOAA subordinate tide station (station ID 9447951)....
Tags: Geomorphology,
Remote Sensing
This portion of the data release presents the raw aerial imagery collected during the unmanned aerial system (UAS) survey of the intertidal zone at West Whidbey Island, WA, on 2019-06-04. The imagery was acquired using a Department of Interior-owned 3DR Solo quadcopter fitted with a Ricoh GR II digital camera featuring a global shutter. Flights using both a nadir camera orientation and an oblique camera orientation were conducted. For the nadir flights (F04, F05, F06, F07, and F08), the camera was mounted using a fixed mount on the bottom of the UAS and oriented in an approximately nadir orientation. The UAS was flown on pre-programmed autonomous flight lines at an approximate altitude of 70 meters above ground...
This portion of the data release presents a digital surface model (DSM) and hillshade image of the intertidal zone at West Whidbey Island, WA. The DSM has a resolution of 4 centimeters per pixel and was derived from structure-from-motion (SfM) processing of aerial imagery collected with an unmanned aerial system (UAS) on 2019-06-04. Unlike a digital elevation model (DEM), the DSM represents the elevation of the highest object within the bounds of a cell. Vegetation, buildings and other objects have not been removed from the data. In addition, data artifacts resulting from noise in the original imagery have not been removed. The raw imagery used to create the DSM was acquired using a UAS fitted with a Ricoh GR II...
Two dams on the Elwha River, Washington State, USA trapped over 20 million m3 of sediment, reducing downstream sediment fluxes and contributing to erosion of the river's coastal delta. The removal of the Elwha and Glines Canyon dams between 2011 and 2014 induced massive increases in river sediment supply and provided an unprecedented opportunity to examine the response of a delta system to changes in sediment supply. The U.S. Geological Survey (USGS) developed an integrated research program aimed at understanding the ecosystem responses following dam removal. The research program included repeated surveys of beach topography, nearshore bathymetry, and surface sediment grain size to quantify changes in delta morphology...
This data release supersedes version 1, published in 2017 under https://doi.org/10.5066/F74M93HF. Please see Version_History_P9HG8UDS.txt below for more information. The San Clemente Dam, built in the 1920s on the Carmel River in Monterey County, California, was removed during 2014 and 2015. The dam-removal project was the largest in California to date, and one of the largest in the U.S. This USGS data release presents data collected before, during, and after the removal of the dam. The data were collected to study how the river channel's topographic profiles and sediment distributions changed in response to new sediment supply after dam removal and base-level changes in the former San Clemente reservoir sediment...
High-resolution topographic surveys were conducted at two pools on the Carmel River between 2014 and 2019 using a survey-grade total station. The Dam Reach pool (DMPOOL) is located within the Dam Reach, approximately 450 meters downstream of the former site of the San Clemente Dam. The Sleepy Hollow pool (SHPOOL) is located within the Sleepy Hollow reach, approximately 2.25 kilometers downstream of the former site of the San Clemente Dam. Both pools were surveyed in 2014, 2015, 2016, 2017, and 2019 using a total station, in conjunction with the channel cross-section surveys also conducted as part of this study (see accompanying file within this data release for topographic survey transect data). For the 2015 survey,...
Categories: Data;
Tags: Bathymetry and Elevation,
CMGP,
Carmel River,
Carmel Valley,
Coastal and Marine Geology Program,
This data release supersedes version 1, published in 2017 under https://doi.org/10.5066/F74M93HF. Please see Version_History_P9HG8UDS.txt below for more information. This dataset contains the easting, northing, and elevation values of the river-right and river-left transect endpoint reference benchmarks (RBM and LBM) from survey transects at 10 survey reaches along the Carmel River, central California. Topographic surveys were completed on these transects during eight summer surveys (in 2013, 2014, 2015, 2016, 2017, 2019, 2020 and 2021). See accompanying file within this data release for elevation measurements. All data were collected in NAD83 UTM10N horizontal coordinates and NAVD88 Geoid 12B vertical coordinates,...
Categories: Data;
Tags: Bathymetry and Elevation,
CMGP,
Carmel River,
Carmel Valley,
Coastal and Marine Geology Program,
To further extend the scope of the Science Application for Risk Reduction (SAFRR) project, detailed hydrodynamic simulations were run at three harbor locations in California. For the locations of 1) Oakland/Alameda, 2) Half Moon Bay, and 3) Santa Cruz, simulations at approximately 5-m resolution were performed using the high-order Boussinesq-type model COULWAVE. The Oakland/Richmond simulation area focuses on the major port facilities in the area and the Half Moon Bay and Santa Cruz simulations focus on Pillar Point Harbor and Santa Cruz Harbor, respectively.
Tags: Geography,
Marine Geology
Note: This data release has been superseded, available here: https://doi.org/10.5066/P9MYL7WJ This data release contains processed high-resolution multichannel sparker seismic-reflection (MCS) data that were collected aboard Humboldt State University’s R/V Coral Sea in October of 2018 on U.S. Geological Survey cruise 2018-658-FA on the shelf and slope between Cape Blanco, Oregon, and Cape Mendocino, California. MCS data were collected to characterize quaternary deformation and sediment dynamics along the southern Cascadia margin.
This dataset consists of physics-based Delft3D model and Delwaq model input files used in modeling sediment deposition and concentrations around the coral reefs of west Maui, Hawaii. The Delft3D models were used to simulate waves and currents under small (SC1) and large (‘SC2’) wave conditions for current stream discharge (‘Alt1’) and stream discharge with watershed restoration (‘Alt3’). Delft3D model results were subsequently used as forcing conditions for Delwaq models to simulate sediment transport and dispersion. The Delwaq models were used to simulate sediment transport and concentrations under the same two wave and stream discharge scenarios. The Delwaq models were run using forcing conditions generated by...
Categories: Data;
Tags: CMHRP,
Coastal and Marine Hazards and Resources Program,
Environmental Health,
Geography,
Geomorphology,
RBRduo pressure and temperature sensors, mounted on aluminum frames, were moored in shallow (< 6 m) water depths in Skagit and Bellingham Bays, Washington, USA, from December 2017 to February 2018, to capture wave heights and periods. Continuous pressure fluctuations are transformed into surface-wave observations of wave heights, periods, and frequency spectra at 30-minute intervals.
Categories: Data;
Types: Map Service,
OGC WFS Layer,
OGC WMS Layer,
OGC WMS Service;
Tags: CMGP,
Coastal and Marine Geology Program,
Marine Geology,
Oceans,
PCMSC,
The lack of geographic and thematic maps of coral reefs limits our understanding of reefs and our ability to assess change. The U.S. Geological Survey (USGS) has the capability to compile digital image mosaics that are useful for creating detailed map products. Image maps covering the shallow near-shore coastal waters have been produced for several of the main Hawaiian Islands, including Hawai‘i, Maui, Moloka‘i, and O‘ahu and are presented in JPEG2000 (.jp2) format. The digital-image mosaics were generated by first scanning historical aerial photographs at 1.0 meter-per-pixel resolution. The individually scanned digital images were tone- and color-matched and then combined together using spatial matching. Separately,...
Types: Map Service,
OGC WFS Layer,
OGC WMS Layer,
OGC WMS Service;
Tags: CMG,
CMGP,
Coastal and Marine Geology Program,
Hawai'i,
Hawaii,
![]() Water depth, turbidity, and current velocity time-series data were collected in Liberty Island Conservation Bank (WVA) in 2017. The turbidity sensors were not calibrated to suspended-sediment concentration at this location. Typically, each zip folder for a deployment period contains two data files from a velocimeter and one data file from a CTD, each of which include data from an optical backscatter sensor. --------- Data were collected from several sites in Little Holland Tract (LHT) and Liberty Island (LI), including the Liberty Island Conservation Bank (LICB), from 2015 to 2017. Table 1 (below) lists the deployment name (DLXXX) and dates for each sampling station location. Station names starting with ‘H’ are...
![]() Water depth, turbidity, and current velocity time-series data were collected in Liberty Island from 2015 to 2017. Depth (from pressure) and velocity were measured in high-frequency (8 Hz) bursts. Burst means represent tidal stage and currents, and burst data can be used to determine wave height, period, and direction, and wave-orbital velocity. The turbidity sensors were calibrated to suspended-sediment concentration measured in water samples collected on site. The calibration and fit parameters for all of the turbidity sensors used in the study are tabulated and provided with the data. Data were sequentially added to this data release as they were collected and post-processed. Typically, each zip folder...
Conductivity-Temperature-Depth (CTD) profile data were collected along transects and across study areas of west Hawaii Island between 2010 and 2014. Measurements were made over a range of tide and weather conditions and help characterize the spatial extent and variability in estuarine conditions across the reef when grouped by 1 to 2-hour survey period or by season.
Categories: Data;
Tags: CMHRP,
Coastal and Marine Hazards and Resources Program,
Freeze Face,
Hawaii,
Honaunau Bay,
Spatial measurements of water temperature, specific conductance, salinity, pH, and dissolved oxygen between 0.25 and 0.50 m water depth were collected every 10-seconds along and across shore at 12 principal study areas along west Hawaii Island. Measurements were made between 2010 and 2013 during different seasons and tide states over the course of 1.0 to 2.5 hours to evaluate the spatial and temporal extent of water properties that influence coral reef health and coral reef habitat availability.
Categories: Data;
Tags: CMHRP,
Coastal and Marine Hazards and Resources Program,
Freeze Face,
Hawaii,
Honaunau Bay,
Time-series data of water level, water temperature, and salinity were collected at 10 locations along west Hawaii Island between 2010 and 2011 in nearshore coral reef settings. Conductivity-temperature-depth sensors were attached to fossil limestone, rock, or dead coral within otherwise healthy coral reef settings spanning water depths of 8 to 23 ft. Continuous measurements were made every 10 or 20 minutes.
Categories: Data;
Types: Map Service,
OGC WFS Layer,
OGC WMS Layer,
OGC WMS Service;
Tags: CMHRP,
Coastal and Marine Hazards and Resources Program,
Freeze Face,
Hawaii,
Honaunau Bay,
|
![]() |